Pop! Mould Plate - 3 piece Set

2 x CLEAR POP MOULD PLATES

1 X POWDER LIFTER

Each mat is A5 in size.

Wash in luke warm water with detergent.  Do not use scourer pads to clean. Also can be cleaned using a soft cloth and rose spirit.

1. Place a small piece of fondant onto your selected mould

2. Use a scraper remove excess fondant, leaving only the design filled with fondant.

3. Place mat onto the Pop Mould/silicone mould design face up. Press firmly down with your thumbs on the center of the design wiggle with some pressure applied, press back and fourth to create friction. You can also use a tiny bit of water on the back of your fondant when its in the mould to help with sticking to the mat.

4. Peel back the Pop! Mould Plate off the mould/acrylic from one end to the other (don't pull it off, peel it,) and your fondant design should be stuck to the Pop Mould mat.

Removing your fondant details from the mat.

1. Apply a little flour to your lifter tool. 

2. Using the corner of your floured lifter, gently go under the design with a 'sawing' action and lift the design off the silicone. 

For best results, allow the mould to dry on the mat prior to removal. Removal time can be anywhere from 5 mins-overnight. 5 minutes you will need to carefully remove with lifter, but if left for hours to overnight they will pop off the mat very easily.